SEKURE DGP2-641 Manual de instalación descargar pdf (Pagina 65)

IGIPLEX

NE C

ONTROL

ANEL

The Seller warrants its products to be free from defects in materials and workmanship under normal use for a period of one year. Except as specifically

stated herein, all express or implied warranties whatsoever, statutory or otherwise, including without limitation, any implied warranty of merchantability and

fitness for a particular purpose, are expressly excluded. Because Seller does not install or connect the products and because th e products may be used in

conjunction with products not manufactured by Seller, Seller cannot guarantee the performance of the security system. Seller obl igation and liability under

this warranty is expressly limited to repairing or replacing, at Seller's option, any product not meeting the specifications. In no event shall the Seller be liable

to the buyer or any other person for any loss or damages whether direct or indirect or consequential or incidental, including without limitation, any damages

for lost profits, stolen goods, or claims by any other party, caused by defective goods or otherwise arising from the improper, incorrect or otherwise faulty

installation or use of the merchandise sold.

ATTACHMENT LIMITATION NOTICE

The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective,

operational and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local tele communications company. The

equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may

not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made

by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the

equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe

system, if present, are connected together. This precaution may be particularly important in rural areas.

CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority, or electrician,

as appropriate.

The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone lo op which is used by the

device to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the Load

Numbers of all of the devices does not exceed 100.

Industry Canada certification is only applicable to installation of devices which include transformers approved by the Canadian Standards Association (CSA).

1 2 ... 60 61 62 63 64 65 66

Comentarios a estos manuales

Sin comentarios

SEKURE DGP2-641 Manual de instalación Pagina 65

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad SEKURE DGP2-641