SEKURE DGP2-648 Manual de instalación descargar pdf (Pagina 10)

8 REFERENCE & INSTALLATION MANUAL

Figure 2-6: Single Zone Input Connections

2.14 DOUBLE ZONE CONNECTIONS

Enabling the ATZ feature (see section 4.2) allows you to install two

detection devices per input terminal. Connect the devices as shown in

Figure 2-7. Devices connected to input terminals must be assigned to a

zone and the zone's parameters must be defined (see Zone Programming

on page 12). For UL listed Burglary System installations only, use EOL

resistor part #2011002000.

Figure 2-7: Double Zone Connections

2.15 CONNECTING THE DGP2-ZX4

The 4-Zone Expansion Plug-in Device* (DGP2-ZX4*) provides four

additional hardwired input terminals (8 zones with ATZ enabled). It

connects directly to the control panel through its on-board

EXPANSION

connector as shown in Figure 2-3: on page 5. Connect detection devices to

the DGP2-ZX4's terminals in the same way that they are connected to the

control panel as shown in Figure 2-6 or Figure 2-7 on page 8. Devices

connected to hardwired input terminals must be assigned to a zone and the

zone's parameters must be defined (Zone Programming on page 12). For

the 4-Zone Expansion Module (APR3-ZX4), refer to the DigiplexNE

Modules Programming Guide.

* Do not use with UL Listed systems.

Enable ATZ (see section 4.2 on page 13)

and connect as follows (extra input

cannot be used)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Sin comentarios

SEKURE DGP2-648 Manual de instalación Pagina 10