SEKURE SX-3100LCD Manual del operador descargar pdf (Pagina 201)

OBD 189

POP-UP MENU FUNCTIONS

When 0.MENU is selected, a menu pops up on the screen. This menu allows selection of

additional display controls and Time Axis modes. The additional functions available are:

Auto Setup, Cursor, Grid Display, Zoom, Waveform Save, and Recall.

1. AUTO The Tester automatically sets the Time Scale, Volt Scale, and Trigger

Level based on the signal measured. This allows the signal to be easily

found on the screen. After AUTO setup is performed, further manual

adjustments may be made to configure displayed waveforms in the most

useful format.

2. CURSOR When 2.CURSOR is selected, the pop-up menu changes to the Cursor

Control menu. Press the key to the left of the cursor selection to change

the setting.

There are two cursors: A and B. The A cursor is represented by a solid

line, the B cursor is represented by a dotted line. Cursors can be moved

with the left and right arrow keys (faster movement can be achieved by

pressing a l and a r). To move the B cursor to the A position

press the y key.

When the cursor is turned on, a three or four line window appears in the

bottom right part of the screen as follows:

XXXXV - Voltage Value at the A (solid) cursor position

X.X ms - Time difference of A and B cursor position

XXXXHz - Computed frequency for above

ACTIVE KEYS

1 Turn cursor off or on.

2 Control A (solid) cursor.

3 Control B (dotted) cursor.

4 Control A and B cursors together.

x Return to previous menu.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 377 378

Sin comentarios

SEKURE SX-3100LCD Manual del operador Pagina 201