SEKURE SX-3100LCD Manual del operador descargar pdf (Pagina 327)

1.0 OPERATING PRECAUTIONS

When operating your diagnostic equipment, always follow these basic safety precautions.

1. Read the instructions in this manual before using the PXA-1000 for the first time.

2. Exhaust gas contains invisible, colorless and odorless poisons. Always vent the vehicle

exhaust and exhaust hoses of the Gas Analyzer to the outside and operate in a properly

ventilated area. This applies to all calibration procedures, as well as to normal exhaust

sampling.

3. It is important that the exhaust coming from the Gas Analyzer be treated the same as

the exhaust coming out of the vehicle’s tailpipe. Therefore, proper routing of the hoses

is required for ventilation of the exhaust and drain hoses.

4. Keep all equipment clear of any moving parts. Follow standard shop safety

precautions, including use of adequate eye protection.

5. Care should be exercised when handling hot exhaust sampling probes to prevent burns.

6. Do not operate a unit with a damaged power cable, or if the unit has been dropped or

damaged, until it has been examined by a qualified service person.

7. This equipment has the potential for internal arcing or sparking and should not be

exposed to flammable vapors. To reduce the risk of explosion, it should be operated in

a well-ventilated area and at least 18 inches above the floor.

8. For safety, a separate driver and operator are necessary when gas analysis is being

performed during road testing.

9. Do not expose the equipment to water or other liquids.

In addition to the basic safety precautions, certain steps should be followed to assure

equipment accuracy and maintain warranty protection.

1. Perform proper filter inspections and replacements. Operation of the analyzer without

filters or with excessively dirty filters can adversely impact performance and void your

warranty.

2. Always operate the analyzer with the drain check valve clean and installed. Fluid

contamination of the analyzer is not covered under your warranty.

3. Do not allow liquids to be sucked into the sample probe.

4. Gas analyzer accuracy will be adversely impacted if the analyzer is operated in below-

freezing or excessively hot conditions. See Appendix E Technical Specifications on

page 366 for more information.

1 2 ... 322 323 324 325 326 327 328 329 330 331 332 ... 377 378

Sin comentarios

SEKURE SX-3100LCD Manual del operador Pagina 327