SEKURE SX-3100LCD Manual del operador descargar pdf (Pagina 352)

340 GAS ANALYZER

Snapshot Save

After completion of Data Capture, the snapshot can be saved for later review.

Press y to save this data set or n to continue without saving the data. The current

snapshot can be reviewed immediately even if not saved.

The snapshot data is saved on the Program Card. Make sure that the same Program Card is

used when reviewing saved snapshot data.

ACTIVE KEYS

y Save snapshot data.

n Continue to Data Display phase without saving snapshot data.

The screen at the left appears if an attempt is made to store a snapshot when the memory is

full.

Data Display Phase

At completion of data capture phase, <Sample> and a time stamp are displayed at the

bottom of the screen. Data captured in the <SNAPSHOT> mode can be displayed in all of

the formats available in the <DATA LIST> mode except for <STRIP CHART> mode.

ACTIVE KEYS

l r Sequence through the sample displayed.

u d Move the display up or down one parameter.

Au Move the display one page. (<DATA LIST> mode only).

y Change the highlighted parameter to the next parameter in the list. (<LED/

LIST>, <BAR GRAPH>, and <LINE GRAPH> modes only).

n Change the highlighted parameter to the previous parameter in the list.

(<LED/LIST>, <BAR GRAPH>, and <LINE GRAPH> modes only).

! Go to <DATA LIST> mode.

@ Go to <LED/LIST> mode.

# Go to <BAR GRAPH> mode.

$ Go to <LINE GRAPH> mode.

( Change between large and compressed character size.

) Turn cursor on and off.

Ah Display parameter information.

s Print data list.

1 2 ... 347 348 349 350 351 352 353 354 355 356 357 ... 377 378

Sin comentarios

SEKURE SX-3100LCD Manual del operador Pagina 352